All known injection molding machine shop are hot, hot, the temperature even reached 35-45 degrees hot summer season or even higher. Some plastic injection molding workshop on environmental conditioning installed or after a lot of high-power axial fan, high temperature hot problem or does not improve, more feel the cooling effect. However, some environmental conditioning to injection workshop factory installed several large central air conditioning, but still hot muggy, no significant improvement.
This is because we do not understand the issue from the roots up, high-temperature injection molding machine shop, mainly from two aspects: Firstly, the process of injection molding machine heating sol; secondly: injection molding machine materials heating and drying process; This is the high temperature injection molding workshop The most fundamental reason, the general material melt temperature at 180-250 degrees; materials are also concentrated in the drying temperature 70-100 degrees, the temperature generated by the two parts, much higher than the plant itself, the natural temperature, thus resulting in a workshop temperature high.
The two main factors for the above, we can find the appropriate solution: one pair plus hot melt process can be installed on the barrel nano infrared heating coil, the electric coil has good insulation properties, good heat insulation, anti- ultra-high-temperature thermal radiation temperature paint, leading to a very low surface temperature, so that the surface temperature can be controlled at between 40-70. In the ultra-low temperature at the same time, more energy-saving rate of protection.
Two installed on the heater shroud airgel insulation, the use of airgel materials nanotechnology manufacturing molding machine energy protective sleeve (Insulaton Heater Cover), using energy-saving protective sleeve forming machine can be a good change of injection environmental and energy-saving industries, improve molding quality, increase productivity, to use business units to bring good economic and social benefits. To maintain a uniform temperature, to reduce the defect rate heater life: double (automatic control heat output), effectively reduce the surface temperature of the barrel is not installed insulation sleeve surface temperature 200 °, after the installation surface temperature about 50 °. Effectively reducing the room temperature to give employees a comfortable environment, mounting barrel insulation kits can save 15% -40%.
Three for drying materials engineering heating can be installed energy-saving servo dryer, in principle, to shorten the heating rods per unit time working hours, which can effectively reduce the room temperature.
Source billion presses professional energy services company, its products cover a nanometer infrared electric rings, injection molding machine molding machine energy shrouds, servo energy saving dryers, servo systems, and presses ANDON warning management system to help enterprises from the fundamental solution high temperature, high energy consumption problem; Company Website: www.yybaowenzhao.com